Nanoxia DS1 Especificações descarregar pdf (Página 14)

Addi onal fans in the side panel:

If you want to accommodate a fan in the side panel, remove the outer cover by loosening the

screws on the inside.

The dust  lter can remain in its posi on.

Please place the fan on the inside of the side

panel above the dust  lter and screw it in

from the outside.

If you secure the cover in the side panel again a er the removal of a side fan, please make

sure not to  ghten the screws not too much. To avoid damage to the internal thread or the

side panel, the screws should be  ghtened by hand only.

Addi onal fans at the case bo om:

If you want to install an addi onal 120 or 140 mm fan on the bo om of the case, remove the

hard drive cage holding  xture located at the bo om. The HDD cage is fastened with four

screws from the underneath of the case.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Sem comentários

Nanoxia DS1 Especificações Página 14